logo
logo
Sign in

Basic Steps on How to Do Electrical Service

avatar
mafa ii
Basic Steps on How to Do Electrical Service

When we think of Electrical Service, what comes to mind? If we think of Electrical Service as something that provides electricity for the common good, then there are many ways that we use it. We use Electrical Service to power our homes, air conditioning units, sheds, garages, pool pumps, hot water heaters, washers, dryers and dishwashers. We use Electrical Service for telephone and internet service, to power small appliances, computer systems and lighting.

Most homes have an electrical service between 100 and 200amps. Ampere is a unit of measurement for electrical current, and this measurement would range from 30 amperes in extremely old houses that haven't been upgraded, to up to 400 amperes in a large home with heavy electric lighting systems. If you are a home owner, you are required by law to have your Electrical service upgrade, or it will be considered a 'hazard'. You will be held responsible for any damage or injury caused by an Electrical service change. There are many things that you can do as a homeowner to help avoid an Electrical service Electricians Glasgow.

The most obvious way to avoid an Electrical service change is by ensuring that your Electrical service is kept up-to-date at all times. Many people are so busy with their daily life, they don't even take the time to check what is going on in their Electrical system. It is best advised that all loose electrical panels are removed from your ceiling fan and moved to an inconspicuous place on your ceiling. Many people, when removing the electrical panels, also unplug the lighting systems that are located above the panels. Unplugging the lighting systems will stop any further damage from occurring and may prevent an Electrical service change.

If there are loose wires in your home or office, it is recommended that they are removed immediately before starting any Electrical service work. Loose utility wiring near or on electrical service panels can create an accident if they are not properly removed. It may even cause injury if they are attached to a circuit breaker panel or other breaker system that is in use. If there are several utility wires, they should be run through a utility snake to make them easier to disconnect. These firings are also helpful in protecting the wires from sparks and flying debris during an Electrical service change.

After checking your main electrical service panel, it is recommended that you check the maximum allowable amps of each of your lighting systems. If you exceed the amperage levels, the voltage of the electricity that is being used can overload your main electric utility company's electric fuse. The overload can cause damage to your main electric utility company's equipment or even an accident. Most homeowners are unaware that if their averages are too high, they can overload the circuit breaker, trip the safety overload, or both.

The next step in proper Electrical service is to flip the appropriate switch on your circuit breaker panel. Before starting any Electrical service repairs, it is important to flip the main circuit breaker first, to verify that all three fuses are in place. After flipping the switch, the amperage limit should be written down inside the box. Then, you can start testing individual circuits. Write down the amperage limits for all circuits individually.

For smaller fuses, especially, it is advisable that you use a utility knife to aid in their removal. This will make sure that you don't cut yourself, while removing the wires. You should only cut the actual wires, not the insulation that is around them. It is important that you keep the power line energized while working on the circuits, so be careful when you are working the fuses. Using a wire stripper or electrician's tape is not advised, because both of them have the tendency to cut through the insulation without the assistance of a tool.

If you have the chance, you should also check the wires that lead to the main breaker box. There could be some shorts there that will result in your system tripping. It is also your responsibility to make sure that the wires are not disconnected from the main breaker. Otherwise, you will have to deal with an overload of electricity that will ultimately result in serious injury, even death.

collect
0
avatar
mafa ii
guide
Zupyak is the world’s largest content marketing community, with over 400 000 members and 3 million articles. Explore and get your content discovered.
Read more