Industries always take various measures to protect their valuable assets and those assets need extra care sometimes, and that is why Synavax’s s Corrosion Control has been made with Nanotechnology which is very effective to protect tanks and other assets which are vulnerable to corrosion.This Corrosion Insulation comes with various benefits such as:1.Non-FlammableFollow Stuart Burchill For More Upcoming Posts.
Energy Efficiency: Advantage of applying a thin layer of the thermal insulation coating, on conductive surfaces.The coating reduces the heat loss, you know 50% of the temperature reduces after applying a very thin layer of thermal coating.UV RAYS: Prevent yourself from UV rays after using the thermal coating.Easy To Coat: Easy to cover hard substances like pipes and conductive surface, product flexibility is good enough.Mold Resistance: Safes substances from the algae and bacterial stuff.Condensation Control: Controls the temperature of the substance that is below the dew point.
There can be the possibility of existing misconceptions when it comes to technology because of less awareness about them.Thermal Insulation is also one of them.Following are the myths or misconceptions of thermal insulation coating:1.Insulation Should Be Thick: Thermal insulation coating is used to stop heat loss and not a single thermal scientist states to use thick material for better insulation.2.Short Life Span: The life span of insulation like wool, fiberglass, or any other can be less but if the insulation is of the latest technology such as Syneffex’s coating, then the life span can be increased by more than 5 years.3.Hard To Apply: Insulation such as fiberglass and wool can be hard to apply but when it comes to Syneffex insulation, it is very easy to apply because of its nature.
Be ready with the following insulation tips for cold months before they start with energy protection.Insulate Ceilings: Collected heat can be lost because of the unprepared roof of the building.Insulating the roof with energy protection can be pretty beneficial when it comes to saving energy by 30 to 50 percent.2.Insulate Walls: Similarly, walls are also the cause of heat loss.It is a wise step to insulate them and stop heat loss that can actually save you some bucks.Insulate Windows & Skylight: These are vulnerable areas when it comes to heat loss.
Benefits for Better:-Marine Industry Insulation:The marine industry is one that is discovering the benefits of a thin film insulation coating in several ship areas, includingFuel systemsSteam pipesBoilersHot and cold water pipesCabinsEngine roomsHull ice storage -Better Trucking Industry InsulationFor refrigerated vehicles, Syneffex thermal insulation coatings reduce fuel costs and keep their trailers cooler without taking up valuable space.-Rail Industry Solutions:The water-repellent nature of our coatings also helps solve unique industry-specific problems, such as the one that Network Rail in the UK was struggling with.They were looking to reduce icicle formation in tunnels that was costing them millions each year in removal costs.Visit Stuart Burchill(CEO at Syneffex Inc.), for more details.
The goal of every facility manager is to do more and also save more when it comes to improving energy efficiency.Following are the ways to reduce costs with Syneffex's coating:1.Insulate Hot Equipments or Steam Pipes to lower process energy costs.2.Building roofs and walls can be insulated using Syneffex coating for insulation.3.Reduce cleaning costs occur due to mold by reducing the chances of mold generation with insulation.Stuart Burchill(CEO at Syneffex) is an excellent inventor and consistently creating products with the motive of more energy-saving and efficiency.
Lead Encapsulation paint can be applied easily just like paint.There are various benefits of lead encapsulation such as:1.More details in wood design2.Elimination of lead dust threatIf you like this post then follow Stuart Burchill and never miss more informative posts.
Mildew Resistance can be categorized into those products which are made up of microbicidal additives and are helpful in resisting mold or algae growth.It also reduces the odors that can be caused by bacterias.Keep updated for more informative posts by Stuart Burchill.
Energy can be lost without the proper insulation in buildings especially areas like walls, skylights, and ductwork.There is one solution to these problems and that is Nano-engineered Energy Protect insulation coating by Syneffex.It can be applied like spray paint and is technically advance with extra benefits such as: 1.Insulation For Walls: Energy Protect is effective on kinds of walls and has shown results in reducing heat transfer.Insulation For Skylights: Translucent nature of Energy Protect is unique and is capable of reducing the effects of UV rays.Insulation For Ductwork: Coating with Energy Protect reduces condensation in ductwork and is moisture resistant which is good for better air quality.Visit Stuart Burchill for more information about Energy Protect.
Ice formation on metal and is one of the issues that come with the winter season which can be unsafe.But there is one natural water-repelling coating solution by Syneffex which have the ability to reduce ice formation that comes with these uses:1.Concrete Tanks: These tanks get moisture that freezes in the winter season, coating the exterior of the tanks can protect the tanks from moisture getting into it.2.Overhead Tunnels & Structures: Ice formation on the tunnel ceilings can be very dangerous because it can fall on the ground.Syneffex’s Coating passed the test and has shown the results of protecting ice formation.3.Pipe Bridges: These pipe bridges are made up of too many pipes holding each other which forms ice and making those pipes heavier & dangerous than before.
Chemical Manufacturers are the ones that should be more aware when it comes to insulation because of the conductivity of the chemicals.Syneffex's EPX-H2O provides the best insulation with many key advantages such as:-Powerful energy-saving, -safe touch solutions, -splash resistance to acidsand moreover, it can also be used on equipment such as:1.Reactors2.Reboilers3.Heat Exchangers4.Chemical storage tanks etc.In case for more information, visit Stuart Burchill(CEO at Syneffex Inc.)
Each and every commercial building must be careful about choosing the right type of materials so that it would be possible to avoid various kinds of threats caused by electricity especially in the case of insulation.Various insulations can be more troublesome such as spray foams.It is obvious to use insulation but they can be also responsible for issues that are dangerous in terms of health and less security.Syneffex's thermal insulation and corrosion prevention coating are successfully delivering results.Our thermal insulation has its own benefits that mainly focus on safety which are listed below:1.Can be used in Food Manufacturing Building without any troubleFollow Stuart Burchill for more upcoming posts.
Larger Tanks have the scope of attracting heat loss or gain and are the exterior insulation can be ineffective.Older insulation is time-consuming and expensive.Syneffex introduces A Spray-on Solution that is moisture and weather resistant with other benefits such as:1.Long-lasting insulating performance2.Resistant to rain and moisture infiltration3.Prevent corrosion and CUI4.Can be sprayed on while the tank is in service and warm/hot5.Splash resistant to chemicals6.Easy to apply.For more upcoming posts, follow Stuart Burchill(CEO at Syneffex Inc.)
Nanotechnology has been used for making products for a few years before.And the products made with the help of Nanotechnology are more efficient and beneficial than before.But most people cannot identify those products which are made by nanotechnology.Below is the list made by Stuart Burchill(CEO at Syneffex Inc.) of those products:1.Bullet Proof Body Armor: Made by Carbon Nanotubes, For more safety and preventing damage.2.Solar Panel: To reduce wastage, solar cells are now made of crystalline silicon which can prove to be more efficient than before.3.Bandages: Engineers have developed ways to create bandages with silver nanoparticles woven into them which will result in better protection from bacteria.If you like information related to Nanotechnology then follow Stuart Burchill for more upcoming info.
Covid - 19 has been now spread all over the world and to reduce it, scientists are working day tonight.In this pandemic, Nanotechnology can play a great role as it can be very helpful.In this image, you can see how Nanotechnology can help us to fight with Covid-19 such as, Modified Masks and Research or Creating Vaccines.If you are interested to know more about Nanotechnology, Then visit Stuart Burchill, who is a Nanotechnology Expert and Inventor.
Nanotechnology is the study of conducting science and engineering on the scales between 1-100 Nanoscale for the purpose of inventing modifying devices.There are a lot of ways with the help of which, we can or are getting benefits from Nanotechnology such as:The advantage for inventions and manufacturing: Nanotechnology provides assistance in building new and unique devices that can ease the thingsEnergy or power advantages: New and efficient devices or products made with the help of Nanotechnology are efficient and better than before, they are made for the purpose of energy saving.Economic Growth: It is impossible for a country to suffer from economic crises if that country is focusing on Nanotechnology-based products and devices.These products in the market never let the economy go down.Advantages for Medical Industries: New medicines or medical devices are getting invented which are proved to be better and effective than before.They are capable of curing diseases and injuries better than before.In the future, no doubt Nanotechnology would be a key factor in production and inventions.We believe inStuart Burchill (CEO/CTO at Syneffex Inc.) and all the other Scientist and Inventors, who are capable of inventing devices which will bring this world a new and better era of lifestyle.
Nanotechnology is making products that are consist of 100 Nanometer-sized things.This technology is the part of science and engineering which control matter on the atomic and molecular scale.If you want to know more about Nanotechnology then visit Stuart Burchill, a well-known Nanotech scientist in the USA.